Heat Pump Replacement Questions

If repair costs are stacking up or comfort is getting worse, replacement usually makes more financial sense. A repair is still reasonable when the issue is isolated and the rest of the system, compressor, coil, line set, is in good condition. Delaying replacement when the compressor is failing risks a full breakdown mid-season with no heating or cooling at all.

The job covers removing the old outdoor condenser and air handler, recovering refrigerant, installing matched new equipment, and running startup commissioning. Line set inspection, ductwork compatibility, and thermostat wiring are all checked as part of the scope.

Not always. If the existing ductwork is in good shape and sized correctly for the new system, it stays as-is. Duct repairs are scoped only when there are confirmed leaks, poor airflow, or a sizing mismatch with the new air handler.

A system running with a failing compressor or low refrigerant charge draws more electricity and delivers less heating or cooling each week. A full breakdown mid-winter in Lakewood leaves the home without heat. Replacing before failure also gives time to size the system correctly rather than rushing a swap.

No. The new system is sized using a load calculation based on your home’s current insulation, window area, and occupancy. Many older Lakewood homes had oversized equipment originally, and matching the old nameplate tonnage repeats that mistake, causing short cycling and uneven temperatures.

Yes. A written post-install record covers the confirmed refrigerant operating pressures and temperature split across the air handler. That baseline makes future service visits faster and gives you a clear record of how the system performed at startup.